WestwooOne X-Digital Systems XDS Podręcznik Użytkownika Pobierz pdf (Strona 2)

Quick Start Guide, XDS PRO4-P Receiver

Rev J - June 2, 2008

Page 2 of 11

Once the satellite RF is properly connected, apply AC power to the receiver and

verify as follows:

• If the SIGNAL LED is green then the receiver is locked to the carrier and

the LCD screen will display:

(Network)

EB ##.# AG ### (# = numerical value)

EB should be above 7 and AG should be between about 40 and 60 for

proper operation.

• If the XDS receiver does not acquire the network carrier, the red FAULT LED

will illuminate steadily and the LCD screen will display:

(Network)

EB _ _._ AG ### (# = numerical value)

Verify proper RF connections, LNB power if required, and the XDS receiver

should automatically lock to the carrier.

To manually tune the XDS receiver to your network carrier:

o At the main screen with the network logo, press the SET key, then the left or

right arrow keys to reach Setup. Press SET.

o Press the left or right arrow keys to reach Tuner. Press SET.

o Press the left or right arrow keys to reach Frequency. Press SET.

Check Network Data Sheet for Frequency

o Use the four arrow keys and the SET key to set the frequency to the value on

the Network Data Sheet packed with your receiver.

o Press the left or right arrow keys to reach Symbol Rate. Press SET.

Check Network Data Sheet for Symbol Rate

o Use the four arrow keys and the SET key to set the symbol rate to the value

on the Network Data Sheet packed with your receiver.

The XDS PRO4-P receiver should lock. (Green SIGNAL LED will

illuminate steadily).

If this XDS receiver is designated to supply DC power to the LNB at your dish, you

can turn on the LNB voltage on the XDS receiver front panel menu as follows:

• Make sure your downlink LNB is connected to the XDS receiver

• Apply AC power to the receiver

1 2 3 4 5 6 7 ... 10 11

Brak uwag

WestwooOne X-Digital Systems XDS Podręcznik Użytkownika Strona 2